Below are some common frequently asked questions regarding the manufacturing and use of industrial brushes. Jenkins Brush has decades of industrial brush experience in all facets of brush manufacturing and their applications both on earth and in outer space (yes we manufactured brushes for space!). We specialize in custom manufacturing of industrial brushes to meet your specific needs. Contact Us and we will be glad to discuss your specific industrial brush needs.
The engagement of the brush should be to a fixed interference point – about 1/32 to 1/16 of an inch, which can be adjusted to allow for wear. Typically, air cylinders are used to engage/disengage the brushes. However, adjusting the engagement by controlling the pressure is not recommended. Excess pressure will produce over-engagement with premature wear and lost power.
Some of Jenkins’ brushes are still in use after 20 years on the job. This is far beyond a normal useful life but it gives you an idea of the durability of a properly maintained brush.
It’s always a good idea to have spares for cleaning.
Check the brush for accumulation of material – the cleaner the brush is, the more effective it is. Watch out for filament wear, especially if the wear is uneven. If it is, adjustments to the machinery are required.
For most applications quarterly is often enough, but inspections should be geared to your regular maintenance schedules.
The minimum speed for your application will produce the best results and the least wear. A good rule of thumb is 2-3 times the speed opposite of travel, but your specific application can have an impact on the results. If you have a question about a specific application, call Craig or send him an e-mail. 1 800 BRUSHES or